Add:Room 305, No. 51, Zone 1, Fifth Industrial Zone, Shangfen Community, Minzhi Street, Longhua District, Shenzhen City, China
Tel:0755-29842909
Fax:0755-29842909
Phone:+8615019258208
Contact:Samer Chen
E-mail:samer@bytracker.com
2G OBD GPS Tracker Real Time Tracking
BY-A2 is a mini, practical and easy-to-use vehicle GPS tracker specially designed for vehicle tracking with fine workmanship. It combines GPS+LBS communication technology. With AGPS technology, this device can easily achieve extreme fast positioning.
According to the set interval time, the default motion mode is reported to a position data in 30s, and the static mode 300s reports a position data.
Alarm
Power down alarm
When device checking the voltage is lower than 5V it will have power down alarm
Over speed alarm
When speed is over than the set speed, device will send message to user.
Other functions
Blind area uploading data
Storage for almost 600pcs and it will
upload the date when the signal is regular
AGPS function
The terminal increases the AGPS support location function and enhances the positioning effect
Inflexion upload
When the angle that vehicle turned is more than a normal scale it will send a message to optimize the playback
Remote upgrading
With a software remote upgrading
Low power consumption
Static mode
The 3D triaxial acceleration sensor can detect the vibration state of the vehicle in real time, and the upper power is the motion mode. When the host is stationary for 5 minutes, it is still mode, and the GPS module is turned off, and the vibration is entered into the motion mode.
Please check whether the equipment is in good appearance & whether accessories are completed.
(2) Set In SIM Card
Please press out the SIM card slot and put SIM card in. Please not put SIM card in or out when the equipment is connecting power. And please make sure the SIM card have data service.
(3) Setup Position
A. Waterproof: Please set the equipment in dry surroundings; keep it away from air-conditioner vents to prevent condensation water inside of the main unit.
B. Anti-Vibrate: tracker cannot installed in where is long term vibrated
C. Anti-interference: tracker should stay away from car audio or intercom devices, to prevent conducted and radiated interference.
3. Device working current is 9-36V, recommended 12V and 24V. Tracker will damage if the current is over this range.
4. Working temperature is -25to 75centigrade, Please cut off power if the temperature is over this range.
5. When vehicle is in underground parks, tunnels or garage, maybe GPS signal will not very good. Communication network blind area will be caused and cannot monitor vehicle. When the car is out of that area, it will working good automatically.
6. Please not repair by yourself when the device not working properly.